The Witch

This is another wood engraving based on an ink drawing I created for the Nox Archaist manual. This was engraved in Resingrave plastic engraving medium which offers smooth lines and pretty good control. The main problem with it is that it does not hold the ink of a layout sketch. I started this print by trying to do an acetone transfer (which worked very well on my Ettin print). The resingrave was having none of it.

Laser print transfer... FAIL!!

So, I reverted to the old standard, transfer paper and lots and lots of tracing. Then reimbursing the lines in ink (which, as mentioned earlier, will just smudge on the resingrave block).

Ink layout lines

It took about a month of hacking away with plenty of COVID-19 booze fuel to keep me going:

Boozin' and Artin'

Here's what the (almost) final block looked like:

Novelty nickel included for scale

I always relish that first ink roll. The block will never look this velvety good after this first proof:

First ink roll on the witch

After this first proof I added more hairs to Black Phillip. With this print I have finally succumbed to the wood engraving cliche of depicting a hairy mammal (the goat is pretty hairy too). Contact me if you want to buy a print (or use Etsy, I get paid more if you buy direct).

Submitted by Robert Gomez on Fri, 04/17/2020 - 22:38